13
4. Advanced preparation
※
MABS units can also be operated individually by inputting/outputting signals from PLCs to each
IB-E06F-M1
Power supply equipment to supply 24V DC to this product (for two units)
①
24V DC power supply
Switching power supply (24V DC/30A, 720W or more)
24V DC battery
Wiring image
Items to be prepared
by customers
Master unit
Term
A MABS unit to operate through signal communications with PLCs.
A MABS unit to operate by receiving signals from the master unit
Synchronized unit
Wiring image
■
The safety circuit includes the emergency stop equipment and magnet contactor.
■
As for the sensor input, and input/output signals of controllers, adopt the number of
inputs/outputs based on customers’ operation. (Details => P.35)
■
A switching power supply is recommended as the DC power supply (24V DC±10%) for
controllers.
■
Use a stabilized power supply that has an adequate capacity of 24V DC and 15A or higher
per 1unit and does not fluctuate due to load variation.
■
If the power supply capacity is less than the rated power of this product, it may result in
malfunction and/or damage due to the supply voltage drop. Be sure to use a power supply
with a capacity larger than the rated power of this product.
■
For the power supply unit, use an isolation type switching power supply compliant with the
safety standard (IEC62368-1). Do not use a non-isolation type power supply for safety
reasons, since it may not conform to the radiation noise regulations.
■
A transformer type power supply cannot be used.
■
Secure a voltage of 24V DC±10% at the power supply terminal of a controller.
■
The power supply should not activate protection with peak current 30A, 1 ms or below per
1 unit.
※
※
※
Specifications for one unit are 24V DC/15A, 360W or more.
MABS main unit
PLC,
etc.
Zone and area sensor
Master unit
controller
Synchronized unit
controller
IB-E06F-M1
IB-E06F-M1
LAN
Master
unit
Synchronized
unit
MABS technical document
Safety precautions
Advanced preparation
Product check
Structures
Installation/Wiring
Control/Operation
Maintenance/Inspection
Troubleshooting
Appendix
IB-E06F-M1 settings
24V DC
power unit
Safety circuit
Breaker
AC power
supply
You can connect up to 8 modules together.
■
Before installing this product prepare the following devices separately.
Original notice - U1.1
