VX121P/151P/171P(-QM57)
User’s manual rev.0.0 (Preliminary)
40 of 68
MU-C656.xxxxxxxxxx r.0.0-EN
8.2 Climatic conditions
Operating temp.:
0 to 45°C;
Storage temp.:
-20 to +60°C.
Relative Humidity: 10 to 90% at 25°C without conden sation.
Notice
It is prohibited to apply sunlight or fluorescent light to the display
during the store.
It is highly recommended to store the Panel PC with temperature from
0 to 35°C and relative humidity of less than 70%.
The operating and storage conditions are dependent on the combination of the
subsystems. The max temperature permitted for the CPU can reduce the max
operating temperature (see the “motherboard” paragraph).
The LCD has not the same display characteristics over full temperature range.
Refer to “LCD” paragraph for further information.
The operating temperature must be measured inside the rack or cabinet where
the Panel PC is installed.
The Panel PC can operate up to max. operating temperature under the following
conditions:
•
The factory-approved heat sink with cooling fan is installed on the CPU and
well operating.
•
The fan on the power supply and on the chassis are well operating.
•
The maximum air inlet temperature for the Panel PC must not exceed the max
operating temperature.
•
The maximum case temperature of the Processor is not exceeded (see the
“Motherboard” paragraph).
•
Power absorbed by expansions (e.g. USB/PCI) is less than 10W.
Notice
Make sure there is suitable room for airflow through the Panel PC
chassis vent.
The power supply fan cooler draw out the inside air flowing it toward
the bottom side. Avoid hot air heap up in the bottom area of the Panel
PC.
