IPOX NVR N9000 Manual
IPOX NVR N9000 Manual
84
9 Alarm Management
9.1 Sensor Alarm
To complete the entire sensor alarm settings, you should enable the sensor alarm of each camera
and then set up the alarm handling of each camera.
①
Click Start
→
Settings
→
Alarm
→
Sensor Alarm to go to the following interface.
②
Select the alarm type (NO or NC) according to trigger type of the sensor.
③
Enable the sensor alarm of each camera.
④
Check the
“
Duration
”
,
“
Record
”
,
“
Snapshot
”
,
“
Push
”
,
“
Alarm-out
”
and
“
Preset
”
and enable or disable the
“
Buzzer
”
,
“
Pop-up Video
”
,
“
Pop-up Message Box
”
and
“
E-
”
as required.
⑤
Click
“
Apply
”
to save the settings.
The configuration steps of the above mentioned alarm linkages are as follows.
Duration:
it refers to the interval time between the adjacent motion detections. For instance, if the
duration time is set to 10 seconds, once the system detects a motion, it will go to alarm and would
not detect any other motion (specific to camera) in 10 seconds. If there is another motion detected
during this period, it will be considered as continuous movement; otherwise it will be considered as
a single motion.
Record:
check it and then the “Trigger Record” window will pop up automatically (you can also
click the “Configure” button to pop up the window). Select camera on the left side and then click
to set the camera as the trigger camera. Select trigger camera on the right side and then click
to cancel the trigger camera. Click “OK” to save the settings. The trigger cameras will record
automatically when the sensor alarm is triggered.
Snapshot:
check it and then the “Trigger Snapshot” window will pop up automatically. Configure
the trigger camera in the window. The trigger cameras will snap automatically when the sensor
alarm is triggered.
Push:
check it and choose NO or OFF. If it is ON, the system will send messages when the sensor
alarm is triggered.
Alarm-out:
check it and then the “Trigger Alarm-out” window will pop up automatically.
