IPOX NVR N9000 Manual
IPOX NVR N9000 Manual
111
12 Device Management
12.1 Network Configuration
12.1.1 TCP/IP Configuration
Click Start
→
Settings
→
Network
→
TCP/IP to go to the following interface. Check
“
Obtain an IPv4
address automatically
”
,
“
Obtain an IPv6 address automatically
”
and
“
Obtain DNS
automatically
”
to get the network addresses automatically, or manually enter the network
addresses. You can modify the MTU value according to the network condition (MTU, Maximum
Transmission Unit, can be modified according to network condition for higher network transmission
efficiency). Click “Apply” to save the settings.
Note:
⚫
Internal Ethernet Port
If you use the NVR with the PoE network ports, click “Internal Ethernet Port” to go to the
following interface. The internal Ethernet port is the port which connects all the PoE ports with the
NVR system. The PoE ports are available if the internal Ethernet port is online; if it is offline, all
the PoE ports will be unavailable, may be the internal Ethernet port is broken. The network
addresses of the internal Ethernet port can be changed to make the port in the same network
segment with the IP cameras which directly connect to the PoE ports of the NVR (it is not
recommended to change the network addresses of the internal Ethernet port). Mode: Non-long line
mode or long line mode can be selectable. The non-line mode is the default setting. If the
transmission performance of your network cables connected the PoE ports and IPC are not so good
or these network cables are very long, you can choose long line mode.
