IPOX NVR N9000 Manual
IPOX NVR N9000 Manual
112
⚫
Multiple Ethernet Ports Setting
If the NVR has two network ports or above, you can select the network work pattern as required.
TOE:
It is a technology for improving the network transmission speed. Please enable it according
to the actual network situation. If TOE is enabled, it shall be high speed mode. Then multiple
address setting or network fault tolerance can be chosen and configured. If TOE is not enabled, it
shall be compatible mode. Then the network fault tolerance cannot be selected and set up.
Network Fault Tolerance:
The two network ports will be bound to one IP address if you select the “Network Fault Tolerance”
pattern. There are many advantages of this work pattern: 1. increase the bandwidth; 2. form a
network redundant array to share the load. When a failure happens to one network port, the other
port will take over the entire load immediately. The takeover process is seamless and the network
service will not be broken off.
Refer to the figure as shown below. If “Network Fault Tolerance” is selected, check “Obtain an
IPv4 address automatically”, “Obtain an IPv6 address automatically” and “Obtain DNS
automatically” to get the network addresses automatically, or manually enter the network addresses;
select one Ethernet port as the primary card and then click “Apply” to save the settings.
