iPECS eMG800
Hardware Description and Installation Manual
Issue 1.8
82
Installation button kit
1)
Set the power mode, protocol type, and PoE class in advance as described above.
2)
Make sure that the Joint Bracket is aligned with the side of the LIP-9048 DSS, and insert the one
side of the Joint Bracket into the mounting holes and insert the other side of the Joint Bracket into
the mounting holes on the side of your phone.
3)
Use the provided screws to connect the LIP-9048 DSS and phone firmly together.
4)
At the back of LIP-9048 DSS and phone, remove the rubber plug from the Accessory Expansion
Module (AEM) port.
5)
Plug the 12-Pin cable into the AEM port on LIP-9048 DSS and phone.
6)
Place the Wire Protective Cover behind the LIP-9048 DSS and align the screw holes with the Wire
Protective Cover screw holes on LIP-9048 DSS.
7)
Tighten the screw to secure the Wire Protective Cover.
See Button kit for the LIP-9000 Series or LIP-9048DSS Quick Installation Guide for more detailed instruction.
Caution!
To avoid damaging the Phone or Button kit, remove power from the phone before installing a Button kit.
