INVT GD20-004G-2-EU, Operation Manual

Page: 94 / 168

Goodrive20-EU series VFD Function parameters
90
Function
code
Name Detailed instruction of parameters
Default
value
Modify
Setting range of P10.(2n, 1<n<17): -100.0
–
100.0%
Setting range of P10.(2n+1, 1<n<17): 0.0
–
6553.5s (min)
P10.34
Acceleration/
deceleration
time selection
of simple PLC
0
– 7 step
Below is the detailed instruction:
Function
code
Binary bit Step
ACC/
DEC 0
ACC/
DEC 1
ACC/
DEC 2
ACC/
DEC 3
P10.34
BIT1 BIT0 0 00 01 10 11
BIT3 BIT2 1 00 01 10 11
BIT5 BIT4 2 00 01 10 11
BIT7 BIT6 3 00 01 10 11
BIT9 BIT8 4 00 01 10 11
BIT11 BIT10 5 00 01 10 11
BIT13 BIT12 6 00 01 10 11
BIT15 BIT14 7 00 01 10 11
P10.35
BIT1 BIT0 8 00 01 10 11
BIT3 BIT2 9 00 01 10 11
BIT5 BIT4 10 00 01 10 11
BIT7 BIT6 11 00 01 10 11
BIT9 BIT8 12 00 01 10 11
BIT11 BIT10 13 00 01 10 11
BIT13 BIT12 14 00 01 10 11
BIT15 BIT14 15 00 01 10 11
After the users select the corresponding
acceleration/deceleration time, the combining 16
binary bit will change into decimal bit, and then
set the corresponding function codes.
Setting range: -0x0000
– 0xFFFF
0x0000
○
P10.35
Acceleration/
deceleration
time selection
of simple PLC
8
– 15 step
0x0000
○
P10.36
PLC restart
mode
0: Restart from the first stage; stop during
running (caused by the stop command, fault or
power loss), run from the first stage after restart.
1: Continue to run from the stop frequency; stop
during running (cause by stop command and
fault), the VFD will record the running time
automatically, enter into the stage after restart
and keep the remaining running at the setting
frequency.
0
◎