20
| Optidrive ODE-3 IP66 Outdoor Rated User Guide |
Version 1.00
www.invertekdrives.com
Parameters
6
6. Parameters
6.1. Standard Parameters
The parameter set is arranged in Groups according to the following structure:
Parameter Group
Range
Access Level
Access Type
P00
P00-01 to P00-20
Extended
Read Only
P00-21 to P00-50
Advanced
Read Only
Basic Parameters
P-01 to P-14
Basic
Read / Write
Extended Parameters
P-15 to P-50
Extended
Read / Write
Advanced Parameters
P-51 to P-60
Advanced
Read / Write
Access to all parameter groups is controlled by setting P-14 as follows:
P-14 = P-37 (Factory setting: 101) Allows Extended Parameter Access
P-14 = P-37 + 100 (Factory Setting: 201) Allows Advanced Parameter Access
In order to prevent possible damage to the drive and connected machinery, certain parameters are locked during operation of the
drive to prevent change. In the case that the drive is enabled, and the user tries to change the parameter, an “L” is shown on the left of
the display.
6.2. Parameter List
6.2.1. Standard Parameters
Par.
Function
Page No.
P-01
Maximum Frequency / Speed Limit
23
P-02
Minimum Frequency / Speed Limit
23
P-03
Acceleration Ramp Time
23
P-04
Deceleration Ramp Time
23
P-05
Stopping Mode / Mains Loss Response
24
P-06
Energy Optimiser
24
P-07
Motor Rated Voltage / Back EMF at rated speed (PM / BLDC)
22
P-08
Motor Rated Current
22
P-09
Motor Rated Frequency
22
P-10
Motor Rated Speed
22
P-11
Low Frequency Torque Boost
22
P-12
Primary Command Source
24
P-13
Operating Mode Select
24
P-14
Extended Menu Access code
26
6.2.2. Extended Parameters
Par.
Function
Page No.
P-15
Digital Input Function Select
26
P-16
Analog Input 1 Signal Format
24
P-17
Maximum Effective Switching Frequency
24
P-18
Output Relay Function Select
25
P-19
Relay Threshold Level
25
P-20
Preset Frequency / Speed 1
26
P-21
Preset Frequency / Speed 2
26
P-22
Preset Frequency / Speed 3
26
P-23
Preset Frequency / Speed 4
26
P-24
2nd Ramp Time (Fast Stop)
23
