Invacare AVIVA RX Series, Service Manual

Page: 25 / 68

Service
1. Remove right-hand shroud.
2. Loosen screws D on left-hand side.
3. Remove shroud
C
forwards.
Fig. 6-2
Installing Shrouds
1. Install parts in reverse order. Tighten screws to 3 Nm.
2. Test all functions.
6.7.2 Water Protection Shroud
• 4 mm Allen key
• 13 mm wrench
• 19 mm wrench
• Oblong wooden block (at least 14 x 14 x 30 cm)
1. Place wooden block underneath mobility device and
prop up mobility device.
2. Remove both power module shrouds. See 6.7.1 Power
Module Shrouds, page 24 .
3. Unplug motor cable.
4. Remove drive wheel. See 6.10.6 Replacing Drive Wheel
(5–Screw Installation), page 48 .
5. Remove motor-gearbox unit. See 6.9.1 Replacing
Motor-Gearbox Unit, page 37 .
6. Remove motor cable B forwards from cutout.
7. Position motor cable at point C .
8. Move shroud D carefully forwards. Pay attention that
snap hooks
A
at top and bottom do not break.
9. Replace shroud.
Fig. 6-3
10. Install parts in reverse order.
11. Test all functions.
6.7.3 Main Frame Shrouds
• 4 mm Allen key
1654647-B 25