•
6 mm Allen key
•
5/8“ Allen key
•
7/8“ Allen key
•
5/16“ Allen key
•
Phillips screwdriver size 2
•
10 mm socket wrench
•
1/2“ socket wrench
•
1/4“ socket wrench
•
5/16“ socket wrench
•
Torque wrench 0 - 25 Nm (or similar)
•
Torque wrench 10 - 80 Nm (or similar)
•
Two long wooden blocks, min. 14 x 14 x 30 cm
Removing sealing ring
1.
Remove motor/gearbox unit, as described in chapter 8.14.2.
2.
Use wrench to loosen and remove nut (2) including washer.
3.
Remove screw (2), which secures sealing ring (3).
4.
Carefully bend sealing ring apart and remove it.
Installing sealing ring
1.
Install sealing ring so square hole for carriage screw is on inside of mobility device.
2.
Insert carriage screw through sealing ring.
3.
Install washer and self-locking nut.
4.
Do not tighten nut completely, as motor orientation must be adjusted during installation.
6.9.3 Replacing motor/gearbox clutch
CAUTION!
Risk of crushing
Motor / gearbox unit is very heavy. Risk of injury to hands.
– Pay attention to heavy weight.
•
5/8“ Allen key
•
7/8“ Allen key
•
5/16“ Allen key
•
6 mm Allen key
•
Phillips screwdriver size 2
•
10 mm wrench
•
1/2“ wrench
•
1/4“ wrench
•
5/16“ wrench
•
Torque wrench 0 - 20 Nm (or similar)
•
Torque wrench 5 - 25 Nm (or similar)
•
Torque wrench 10 - 80 Nm (or similar)
•
Two long wooden blocks, min. 14 x 14 x 30 cm
1654647-B
39
