IntesisBox
®
KNX - Daikin A.C. (SKY & VRV line)
User's manual r1.0 eng
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SL
URL
Email
tel
http://www.intesis.com
[email protected]
+34 938047134
51 / 66
This parameter lets select the decreasing step value (in %) that will be sent for a long
operation.
Short/long operation limit (x100ms)
This parameter lets introduce the time period difference for the short and the long
operation.
Cycl. send. period in long oper. (x100ms)
This parameter lets configure a time (in seconds) for the cyclical sending of a long
operation.
o
When
“Shutter/Blind”
is selected the communication objects and new parameters for
the Input “x” will appear as shown below.
Figure 4.44
Parameter detail
Send telegram after bus recovery
This parameter lets select if the Binary Input “x” will send a telegram, or not, after a
bus recovery and the type of telegram sent (if enabled).
When
“No action”
is selected, no telegram will be sent after a bus recovery.
When
“Move Up”
is selected, the binary input will send a telegram with a
“0”
value after a bus recovery. Also a new parameter will appear (see below).
When
“Move Down”
is selected, the binary input will send a telegram with a
“1”
value after a bus recovery. Also a new parameter will appear (see below).
Figure 4.45
Parameter detail
Sending delay after a bus recovery (seconds)
