IntesisBox
®
KNX - Daikin A.C. (SKY & VRV line)
User's manual r1.0 eng
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SL
URL
Email
tel
http://www.intesis.com
[email protected]
+34 938047134
31 / 66
This parameter lets you choose if SWING function is included (
“yes”
) or not (
“no”
)
in the sequence when using
Control_ Vane Up-Down +/-
object as shown in the
discontinuous segment at the picture below.
Rollover Vane at upper/lower limit
This parameter lets choose if roll-over will be enabled (
“yes”
) or disabled (
“no”
) for
the
Vane Up-Down +/-
object.
4.5.5 Enable use of bit-type Vane U-D objects (for Control)
This parameter shows/hides the bit-type
Control_ Vane Up-Down
objects.
o
If set to
“no”
the objects will not be shown.
o
If set to
“yes”
the
Control_ Vane Up-Down
objects for each Position (1 to 5) will appear.
To activate a Vane Position by using these objects, a
“1”
value has to be sent.
4.5.6 Enable use of bit-type Vane U-D objects (for Status)
This parameter shows/hides the bit-type
Status_ Vane Up-Down
objects.
o
If set to
“no”
the objects will not be shown.
o
If set to
“yes”
the
Status_ Vane Up-Down
objects for each Position (1 to 5) will appear.
When a Vane Position is enabled, a
“1”
value is returned through its bit-type object.
Up / Increase
Down / Decrease
Pos. 3
Pos. 1
Pos. 2
Only if Roll-over is enabled
Only if Roll-over is enabled
Pos. 5
Pos. 4
SWING
