IntesisBox
®
KNX - Daikin A.C. (SKY & VRV line)
User's manual r1.0 eng
© Intesis Software S.L. - All rights reserved
This information is subject to change without notice
IntesisBox
®
is a registered trademark of Intesis Software SL
URL
Email
tel
http://www.intesis.com
[email protected]
+34 938047134
26 / 66
Figure 4.14
Parameter detail
DPT type for +/- Fan Speed Object
This parameter lets choose between the datapoints
0-Up / 1-Down [DPT_1.008]
and
0-Decrease / 1-Increase [DPT_1.007]
for the
Control_ Fan Speed +/-
object.
Roll-over Speed at upper/lower limit
This parameter lets choose if roll-over will be enabled (
“yes”
) or disabled (
“no”
) for
the
Control_ Fan Speed +/-
object.
4.4.4 Enable use of bit-type Fan Speed objects (for Control)
This parameter shows/hides the bit-type
Control_ Fan Speed
objects.
o
If set to
“no”
the objects will not be shown.
o
If set to
“yes”
the
Control_ Fan Speed
objects for Speed 1, Speed 2 and Speed 3 (if
available) will appear. To activate a Fan Speed by using these objects a
“1”
value has to
be sent.
4.4.5 Enable use of bit-type Fan Speed objects (for Status)
This parameter shows/hides the bit-type
Status_ Fan Speed
objects.
Up / Increase
Down / Decrease
Fan Speed 3
Fan Speed 1
Fan Speed 2
Only if Roll-over is enabled
Only if Roll-over is enabled
