Intermec 6950 EGS, User Manual

Page: 32 / 144

SECTION 3 Installation
3-16 6950 Enterprise Gateway Server User’s Guide
Connecting to Ethernet
The following pages show how to connect the 6950 EGS to
10BASEĆ2 (early model only), 10BASEĆT, and 100BASEĆT
(current model only).
10BASE2
The early model of the 6950 EGS can connect to the end or
middle of the 10BASE2 cable segment.
"
NOTE: Cable lengths between network devices on the 10BASE2 Ethernet
LAN must meet ANSI/IEEE standards.
End of Segment
See the following procedure and Figure 3Ć13.
1. Plug the TĆconnector (2) into the BNC port.
2. Plug one end of the Ethernet cable (3) into an open
end of the TĆconnector. Align the notches in the cable
end with the posts on the TĆconnector, push the cable
in, and twist oneĆfourth turn.
3. Plug the cable terminator (1) into the other end of the
TĆconnector.
Middle of Segment
See the following procedure and Figure 3Ć14.
1. Plug the TĆconnector (2) into the BNC port.
2. Plug one end of the Ethernet coaxial cable (1) into an
open end of the TĆconnector. Align the notches in the
cable end with the posts on the TĆconnector, push the
cable in, and twist about oneĆfourth turn.
3. Plug the end of another Ethernet coaxial cable
segment into the other open end of the TĆconnector.