Intellijel Tete, User Manual

Page: 46 / 173

Tête + Tetrapad Manual
This type of crossfader sends 100% of the maximum voltage to both the left and right jacks when your
finger is in the middle of the pad.
Sliding your finger up the pad (from center) decreases the voltage being sent to the left output until, at
the top of the pad, 0V is sent to the left jack.
Sliding your finger down the pad (from center) decreases the voltage being sent to the right output
until, at the very bottom of the pad, 0V is sent to the right jack.
NOTE: In Shift view, you can turn an encoder to set a crossfader’s maximum voltage to either 1V, 2V,
3V, 4V or 5V, with 5V being the default value (as discussed in
​ Using Crossfaders ​ , below).
DJ Cut:
This type of crossfader is similar to the Fade type
(above), except that the left output fades away only in
the top 20% of the pad (rather than the top half of the
pad), while the right output fades away only in the
bottom 20% of the pad.
Maximum voltage is therefore sent out both jacks for a
wide swath throughout the middle range of the pad.
NOTE: In Shift view, you can turn an encoder to set a
crossfader’s maximum voltage to either 1V, 2V, 3V, 4V
or 5V, with 5V being the default value (as discussed in
Using Crossfaders ​ , below).
Page 45