Intellijel Tete, User Manual

Page: 160 / 173

Tête + Tetrapad Manual
Position Sync with Sequences
After Loopy has played back a series of sub-steps, playback of the full-length sequence is resumed.
The precise position at which playback resumes is determined by the
​ Loopy Pos. Sync ​ parameter,
located in the Mode SETUP Menu.
Specifically:
1. Press Tête’s ​ SETUP ​ MODE ​ button, and scroll down to the ​ Loopy Pos. Sync ​ parameter.
There are two options: ​ Off
​
and ​ On
​
.
2. If you want the playback to snap to the position where it would have been had you never
engaged Loopy, then set
​ Loopy Pos. Sync ​ to ​ On
​
.
3. If you want the playback to continue to play from the position you were in within Loopy, set
Loopy Pos. Sync ​ to ​ Off
​
.
The following examples illustrate the difference between these two options:
1. Assume your Sequence is the 8-steps shown on the top line (below), and your Loopy segment
is the demarcated 2-step subset length:
Page 159