Intellijel Tete, User Manual

Page: 164 / 173

Tête + Tetrapad Manual
Position Sync with Loops
After Loopy has played back a series of sub-loops, playback of the full-length loop is resumed. The
precise position at which playback resumes is determined by the
​ Loopy Pos. Sync ​ parameter,
located in the Mode SETUP Menu.
Specifically:
1. Press Tête’s
​
SETUP
​
MODE
​
button, and scroll down to the
​
Looper Sync
​
parameter.
If ​ Looper Sync ​ is set to ​ Off
​
, then the ​ Loopy Pos. Sync ​ parameter appears, with two choices:
Off
​
and
​
On
​
.
If ​ Looper Sync ​ is set to ​ On
​
, then ​ Loopy Pos. Sync ​ is automatically set to “on” (described
below), and no Loopy Pos. Sync parameter exists.
2. If you want the playback to snap to the position where it would have been had you never
engaged Loopy, then set
​
Loopy Pos. Sync
​
to
​
On
​
(or set
​
Looper Sync
​
to
​
On
​
).
3. If you want the playback to continue to play from the position you were in within Loopy, set
Loopy Pos. Sync
​
to
​
Off
​
.
The following examples illustrate the difference between these two options:
1. Assume your Loop is the length indicated by the
​
RED
​
line (below), and your Loopy segment is
the length indicated by the ​ BLUE ​ line (below):
2. Assume you start playing Loopy at the position indicated by the ​ RED ​ arrow (below), and that
you play the Loopy segment 4 times. If
​
Loopy Pos. Sync
​
is set to
​
On
​
, then when Loopy stops
playing, the original full length loop will continue playing from the point marked by the ​ BLUE
arrow.
3. If, instead, you set ​ Loopy Pos. Sync ​ to ​ Off
​
, and play Loopy 4 times starting at the position
indicated by the ​ RED ​ arrow (below), then when Loopy stops playing, the original full length
loop will continue playing from the point marked by the BLUE arrow (below).
Page 163