Intellijel Tete, User Manual

Page: 93 / 173

Tête + Tetrapad Manual
Reset a Voltage
To quickly reset a voltage to 0V:
1. Touch a virtual pad and keep your finger on the pad (bank).
2. Press an Encoder to reset the corresponding output voltage to 0V.
If the SHIFT LED is ​ green ​ , the four encoders reset Outputs 1-4. If the SHIFT LED is ​ red ​ , the
four encoders reset Outputs 5.-6. Pressing the red SHIFT button toggles between these two
states.
Slew Between Voltages
Normally, output voltages change instantly when you press different virtual pads (banks) on Tetrapad.
However, it’s possible to assign a slew, so that the voltages change gradually.
To slew between voltages:
1. Hold down the red SHIFT button and rotate any of the four Encoders.
Slew is global, and affects all 8 outputs simultaneously.
Clockwise rotations increase the time it takes to switch from one voltage to another (up to a
maximum of about two minutes to complete a 10 V change). Counterclockwise turns decrease
the amount of time it takes to switch between voltages (down to “instantaneous”).
The slew time is indicated by a red Pad Status LED above all four pads — with the LED
glowing increasingly brighter as the slew gets longer. When there is no slew (Shift-hold and
turn encoder counterclockwise), the LED is not lit.
Quantizing Voltage Values
Output voltages can be quantized to conform to a chosen musical scale. To do so:
1. Press a pad’s encoder to toggle output quantization on/off.
When an output voltage is quantized, its Output Status LED turns blue, indicating the jack
contains pitched voltages.
2. On Tête, press the ​ SETUP ​ MODE ​ button to display the Mode SETUP menu.
3. Turn Tête’s encoder to select the Scale and Scale Root options, and set them to the desired
values as discussed further in
​ Voltages Mode SETUP Menu ​ .
4. Press the
​
SETUP
​
MODE
​
button again to exit the Mode SETUP menu and return Tête to its
default display.
Output voltages will now be quantized to conform to the chosen musical scale.
Page 92