Intel® Server System M50CYP2UR Family System Integration and Service Guide
100
Figure 124. Memory Module Installation
8.
Locate the DIMM slot for installation.
9.
Ensure that the DIMM ejection tabs at both ends of the DIMM slot are pushed outward to the open
position (see Letter A).
10.
Carefully unpack the replacement Memory module, taking care to only handle the device by its outer
edges.
11.
Align the notch at the bottom edge of the Memory module with the key in the DIMM slot (see Letter B).
12.
Insert the Memory module into the slot (see Letter C), push down on the Memory module until the
ejection tabs snap into place (see Letter D).
13.
Ensure that the ejection tabs are firmly in place (see Letter E).
14.
Reinstall the air duct (see
Section 6.2.2
15.
Reinstall system top cover (see
Section 6.1.2
).
6.6
Power Supply Module Replacement
Required Tools and Supplies
•
Anti-static wrist strap and conductive workbench pad (recommended)
Caution:
The power supply is only hot-swappable (system does not have to be powered down) if the system
is configured with two power supply modules operating in a 1+1 redundant configuration.
Systems with a single power supply installed or a system operating in a 2+0 non-redundant power mode,
MUST be powered OFF before removing the power supply module from the system.
