Intel® Server System M50CYP2UR Family System Integration and Service Guide
32
Figure 21. PHM Installation onto Server Board
4.
Set all four anti-tilt wires on the heat sink to the inward position (see Letter A).
5.
Holding the
PHM horizontally, carefully lower it on to the bolster plate’s alignment pins (see Letter B).
6.
Set all four anti-tilt wires on the heat sink to the outward position (see Letter C).
Figure 22. Tighten Heat Sink Fasteners
7.
Tighten the heat sink fasteners using a T30 Torx* screwdriver to 8 in-lb. No specific sequence is needed
for tightening.
Important:
Do not install a processor heat sink on an empty socket. Only install a socket cover on an empty
socket.
