20
En
With
u
(Remote Interactive), you can use the following
special functions:
■
System On/Auto Power On
When you start playback on a component connected via
u
while the AV receiver is on Standby, the AV
receiver will automatically turn on and select that
component as the input source.
■
Direct Change
When playback is started on a component connected via
u
, the AV receiver automatically selects that
component as the input source.
■
Remote Control
You can use the AV receiver’s remote controller to
control your other
u
-capable Integra/Onkyo
components, pointing the remote controller at the AV
receiver’s remote control sensor instead of the
component. You must enter the appropriate remote
control code first (
➔
page 72
).
Note
• Use only
u
cables for
u
connections.
u
cables are supplied
with Integra/Onkyo components.
• Some components have two
u
jacks. You can connect either
one to the AV receiver. The other jack is for connecting
additional
u
-capable components.
• Connect only Integra/Onkyo components to
u
jacks.
Connecting other manufacturer’s components may cause a
malfunction.
• Some components may not support all
u
functions. Refer to
the manuals supplied with your Integra/Onkyo components.
• While Zone 2 is on, the System On/Auto Power On and Direct
Change
u
functions do not work.
See “Recording” for details on recording (
➔
page 42
).
Note
• The AV receiver must be turned on for recording. Recording is
not possible while it’s in standby mode.
• If you want to record directly from your TV or playback VCR to
the recording VCR without going through the AV receiver,
connect the TV/VCR’s audio and video outputs directly to the
recording VCR’s audio and video inputs. See the manuals
supplied with your TV and VCR for details.
• Video signals connected to composite video inputs can be
recorded only via composite video outputs. For example, if your
TV/VCR is connected to a composite video input, the recording
VCR must be connected to a composite video output.
• The surround sound and DSP listening modes cannot be
recorded.
• Copy-protected Blu-ray Discs and DVDs cannot be recorded.
• Sources connected to a digital input cannot be recorded. Only
analog inputs can be recorded.
• DTS signals will be recorded as noise, so don’t attempt analog
recording of DTS CDs or LDs.
Connecting Integra/Onkyo
u
Components
1
Make sure that each Integra/Onkyo component is
connected with an analog audio cable (connection
G
in the hookup examples) (
➔
page 18
).
2
Make the
u
connection (see the illustration).
3
If you’re using an RI Dock, or cassette tape deck,
change the Input Display (
➔
page 41
).
L
R
ANALOG
AUDIO OUT
L
R
ANALOG
AUDIO OUT
e.g., CD player
RI Dock
Connecting a Recording Component
AUDIO
IN
L R
VIDEO
IN
VCR, DVD recorder,
cassette tape deck,
CDR, MD recorder, etc.
