61
En
■
Proxy URL
To use a Web proxy, enter its URL here.
■
Proxy Port
If you’re using a Web proxy, enter a proxy port number
here.
■
Network Control
`
Enable
`
Disable
This setting enables or disables control over the network.
Note
• When set to “
Enable
”, the
NET
indicator is dimly-lit and the
power consumption slightly increases in standby mode.
■
Control Port
`
“
49152
” to “
65535
”
This is the network port used for control over the network.
Note
• When the “
Network Control
” setting is set to “
Disable
”, this
setting is cannot be selected.
Firmware Update
See “Firmware Update” for the update procedure
(
➔
page 82
).
Note
• Perform the firmware update only when such an announcement
is posted on the Integra web site. Visit the Integra web site for
the latest information.
• It takes maximum 60 minutes to complete the firmware update.
■
Version
Displays the current version of the firmware.
■
Receiver
`
via NET
:
Performs the firmware update via Internet. Check
the network connection before updating.
`
via USB
:
Performs the firmware update from a USB device.
These settings allow you to update the AV receiver’s
firmware. Do not shutdown the power of the AV receiver
while updating.
■
Universal Port
`
via NET
:
Performs the firmware update via Internet. Check
the network connection before updating.
`
via USB
:
Performs the firmware update from a USB device.
These settings allow you to update Onkyo dock’s
firmware. Do not shutdown the power of the AV receiver
while updating.
Note
• This update shall not be performed when no dock is connected
to the
UNIVERSAL PORT
jack.
Main menu
Remote Controller Setup
Remote Mode Setup
See “Looking up for Remote Control Code”
(
➔
page 71
).
With this preference, you can protect your settings by
locking the setup menus.
Main menu
Lock Setup
■
Setup
`
Locked
`
Unlocked
When “
Locked
” is selected, the setup menus will be
locked and you cannot change any setting.
You can change various audio settings from the Home
menu (
➔
page 40
).
Note
• These settings are not available in either of the following cases:
– a pair of headphones is connected.
– the “
Audio TV Out
” setting is set to “
On
” (
➔
page 59
).
– “
HDMI Control(RIHD)
” is set to “
On
” (
➔
page 58
) and
you’re listening through your TV speakers.
Tone Control Settings
■
Bass
`
–10dB
to
0dB
to
+10dB
in 2 dB steps.
You can boost or cut low-frequency sounds output
from the front speakers.
■
Treble
`
–10dB
to
0dB
to
+10dB
in 2 dB steps.
You can boost or cut high-frequency sounds output
from the front speakers.
You can adjust the bass and treble for the front speakers,
except when the Direct or THX listening mode is selected.
Remote Controller Setup
Lock Setup
Using the Audio Settings
1
Press
Receiver
followed by
Home
.
2
Use
q
/
w
and
Enter
to select “Audio”, and then use
q
/
w
/
e
/
r
to make the desired selection.