INSYS MoRoS GPRS 2.1 PRO, Manual

Page: 54 / 144

Functions MoRoS GPRS 2.1 PRO
12.4 Dial-Out
12.4.1 Configure Dial-Out
You can use the MoRoS GPRS 2.1 PRO for dial-out. The MoRoS GPRS 2.1 PRO will
automatically establish a PPP connection to a remote terminal, when the network
traffic occurs in the direction of the network of the terminal. The network traffic
which may trigger a connection setup can be limited by rules. This optional "Dialing
filter" will ensure that only packets from/to certain IP addresses or from/to certain
ports trigger the dial-out connection. This dial-out connection can be compared with
the dial-in of a PC into the Internet. Only after this dial-in, it will be possible to trans-
fer IP data (e.g. web contents) or to remotely access devices in the local network of
the MoRoS GPRS 2.1 PRO, for example.
Configuration via the web interface
In order to enable dial-out, select in the menu "Dial-Out" on the page
"Dial-Out" the option "Yes" for "Activate Dial-Out".
For a GSM-CSD connection, enter the phone number of the PPP terminal
(e.g. the Internet provider) into the entry field "Phone number" for destina-
tion A. You may enter a further phone number (or "*99***1#" for a
packet-based connection, see below) for destination B.
Enter for a packet-based connection (GPRS/EDGE/UMTS/HSDPA)
"*99***1#" into the entry field "Telephone number" for Target A. For des-
tination A, enter the APN of your mobile provider, which is used to estab-
lish a packet-based connection, into the field "Access Point Name". You
can enter another APN for Target B. As an alternative, you may also define
a GSM-CSD connection with a usual phone number for Target B.
Enter a User name and Password for the PPP dial-up destinations A and B.
The specification of destination B is optional. The user name must not be
identical with the one of a dial-in user.
Select the PPP authentication method (PAP, CHAP, and PAP or CHAP) to
be used for Targets A and B in the selection "Authentication".
If you use a second SIM card, you may select the SIM card to be used for
Target B under "SIM card for target B". SIM card 1 is always used for Tar-
get A.
Enter a value for "Idle time" to define how long the connection will remain
established, if no data transfer takes place. Enter the required time in sec-
onds into the field "Idle time".
To maintain the connection for an unlimited time, enter the value "0".
Enter the Maximum connect time to limit the duration of a connection. If
you enter a maximum connection time, the connection will be closed after
this time period has expired. To keep the connection open without any
time restrictions (until the connection is terminated for other reasons), en-
ter the value "0" in the field "Maximum connect-time".
54