a.
Slide the Upright Sleeve (36) onto the Upright Post (4.) Refer to the insert drawing. Make sure the
direction of the Upright Sleeve (36) is in the correct position.
b. Plug the Middle Connection Wire (131) into the Lower Connection Wire (132).
STEP 3: Upright Post Assembly
a.
Ensure 2pcs Nylock Nuts (M10xp1.5)(125) have preassembled into the front of the Main Frame (1) as
FIG1 illustration (they will not be tight so that slotted bracket of the upright post will slide between the
nut and the frame).
b. Insert the Upright Post (4) into the Main Frame (1) and secure with 2pcs Bolts (M10xp1.5x50mm)(117)
by using the T-HEAD SOCKET WRENCH as shown.
NOTE: Please do not fully tighten Bolts (117) or Nuts (125) until Step. 5 has been COMPLETED.
c.
Slide the Upright Sleeve (36) down to cover the open area of the Main Frame (1).
STEP 4: Pedal Support Arm & Pedal Arm Assembly
a.
Attach the Right Pedal Arm (13) onto the Right Pivoting Arm (9) and secure with one Bolt
(M10xp1.5x85mm)(116) and one Nylon Nut (M10xp1.5)(126).
b. Attach the Right Pedal Support Arm (11) onto the Right Pivoting Arm (9) and secure with one Bolt
(M10xp1.5x70mm)(115) and one Nylon Nut (M10xp1.5)(126).
c.
Repeat the above same procedure on the left side.
NOTE: Make sure the bolts and nuts are fully tightened before moving to the next step.
STEP 5: Front Decoration Cover Assembly
a.
Please go back to fully tighten with 2pcs Bolts (M10xp1.5x50mm)(117) and 2pcs Nylock Nuts
(M10xp1.5)(125) with the T-Handle SOCKET WRENCH (17mm) as shown below.
10
