61
730
VIEW
1. Press Utility key;
2. Select the "test" function menu;
3. Confirm;
4. Select the key BIT;
5. Confirm;
6. Operate each entity key one by one, and Display C displays the number corresponding to the key in turn;
7. Press "Enter" key twice continuously to exit the BIT mode.
Description of key BIT
A corresponding number will be assigned to all keys respectively (except the power switch key) inside the instrument.
After entering the key BIT state, press any key, and Display Bar D will display the number information of the key to confirm
effective operation of the key. Press "Enter" key twice continuously to exit the key BIT mode.
9.9.1 Saving of configuration file
Operating steps
9.9 Saving and Loading of Configuration File
The parameter setting file of the instrument can be saved in the internal memory of the instrument. A total of four sets
of parameter configurations can be saved, and File1, File2, File3 and File4 are used respectively to represent the storage
destination of the configuration file. The configuration file shall be saved, so that the configuration will be loaded quickly
when encountering similar measurement environment in the later period, and the time for users to set the parameters
again shall be reduced.
1. Press the Setup key;
2. Select the "save" function menu;
3. Confirm;
4. Select the directory folder (File1~File4) where the files will be saved;
5. Confirm;
6. Exit and close the setting menu.
