Terminal User Guide
Page 71
iWL250 User Guide
Copyright© 2019 Ingenico
Stored Transaction Report
A Stored Transaction report may be printed to show how many transactions are
stored in the terminal, awaiting transmission to the host.
Up to five transactions may be stored in the terminal per acquirer. A transaction
may be stored after contactless transaction, voice referral, or by using the Forced
Transaction or Hotel Mode Completion functions.
Do not print this report unless instructed to do so by the terminal
Helpdesk.
To perform a Stored report for ALL acquirers press the menu key twice, then
choose REPORTS and press enter. You will be asked to type your supervisor
password, then press enter, press the menu key once more, choose STORED
followed by selecting ALL.
To perform a Stored report for a SINGLE acquirer press the menu key twice, then
choose REPORTS. You will be asked to type your supervisor password, then
press enter, press the menu key once more, choose STORED then choose
SINGLE. Select from the list the required acquirer
TMS Report
Approximately once a month your terminal will call the Terminal Management
System (TMS) to receive any updates to the software, details of new card
schemes, and any changes to your configuration. This call will take place
automatically, normally outside of standard trading hours.
After the TMS call has taken place your terminal will print a TMS report, indicating
if the communication was successful or has failed.
If the TMS call is interrupted part way through downloading a new or updated
configuration file, for example due to a communications problem, the terminal will
be set into a NOT READY state, and will not be usable until the file has been
downloaded.
If your terminal displays the NOT READY status message then your terminal is
not initialised. Press menu once, and choose the SETUP menu option. You
