Nix Product Manual |
Connectors Guide
INGENIA | 01/22/2019
47
Mating connectors
If instead of soldering, a pluggable PCB is needed, following mating connectors are suggested.
Supply, shunt
and motor
Power pin
receptacle.
Gold plated.
Milli-Max
3044-0-15-15-23-27-04-
0
Digi-Key
7
Feedback
8-way pin
receptacle
8.5 mm height
2.5 mm width
Gold flash
Sullins PPPC081LFBN-
RC
Digi-Key
2
Absolute
encoder
3-way pin
receptacle
8.5 mm height
2.5 mm width
Gold flash
Sullins PPPC031LFBN-
RC
Digi-Key
2
I/O
6-way pin
receptacle
8.5 mm height
2.5 mm width
Gold flash
Sullins PPPC061LFBN-
RC
Digi-Key
2
Connector
Description
Part number
Image
Distributor
code
Quanti
ty
Routing the PCB
•
The
traces should always be as short as possible
to minimize potential EMI issues.
•
Take due care with
signal returns
and GND routing, especially for high speed signals and analog
inputs.
•
Do NOT use a general ground plane
as this could cause unwanted ground loops.
• The
width of the traces
should be according to the current carrying capacity. For motor and supply
traces use generous thick traces.
•
Spacing of the traces
on external layers is crucial to guarantee safety. Recommended spacing for
power and motor lines should exceed 0.4 mm (1.5 mm recommended).
•
Keep power and signal traces separated.
