InfoPrint 6500-v05, User Manual

Page: 42 / 340

occurs only in the READY state. When pressed, the
“059 CANCEL PRINT ACTIVE” message is displayed.
Twinax Interface
Effective in the READY and NOT READY states. When
pressed, the “059 CANCEL PRINT ACTIVE” message is
displayed.
IPDS Interface
Ethernet (IPDS mode): Effective in the NOT READY
state. The two forms of cancel are:
a. Full Cancel: A CANCEL command is sent to the
host requesting that the print job be cancelled and
the next job in the queue be submitted for printing.
This is done by pressing the
CANCEL key twice.
When pressed, the “059 CANCEL PRINT ACTIVE”
message is displayed.
b. Clear Buffers: A Clear Buffers command is sent to
the host informing the host that the printer has
cleared its buffers. At this point, the job can be
restarted from any page based on the instruction
from the host. This is done by pressing the
CANCEL key once, then pressing the STOP key.
When pressed, the “069 DATA CLEARED” message
is displayed.
Serial/Parallel/Ethernet Interface
We recommend that you stop the print job from the
host system before you press
CANCEL . Effective in the
NOT READY state. When pressed, the “069 DATA
CLEARED” message is displayed.
EJECT The EJECT key has two modes of operation. Standard mode is the
only mode available on the cabinet models. For pedestal models
(without zero tear option), the Standard mode can be selected from
the menu and should be selected when using the rear paper exit.
In Standard mode, the
EJECT key moves the paper forward to
facilitate tearing off the paper at the perforation then restores the
original paper position. Once the paper is torn at the perforation,
pressing either the
EJECT
,
START
, or
Stop
keys retracts the paper
to its previous position, as described below:
EJECT Moves the paper to its previous position. The printer
returns to the mode it was in before
EJECT was used.
START
Moves the paper to its previous position and places the
printer in the
READY state.
STOP Moves the paper to its previous position and places the
printer in the
NOT READY state.
If the paper is to be torn off, the FORM FEED key must be pressed
before pressing the EJECT , START , or STOP keys. This feeds an
additional page first and prevents the paper from unloading when
it is restored to its original position after the form is torn off.
For pedestal models (without zero tear option), in the Top Exit Tear
mode (selectable at the operator panel), this key moves the paper
to the top of the next form. In the
NOT READY state, pressing the
26
InfoPrint 6500-V User’s Manual