InfoPrint 6500-v05, User Manual

Page: 247 / 340

Table 11. Fault Messages (continued)
Fault Message
Operator
Correctable?
Explanation Solution
165 ERROR: NO DRAM
DETECTED No The printer could not find
any DRAM. Contact your InfoPrint
Solutions Company service
representative.
166 ERROR: NVRAM FAILURE No The nonvolatile SRAM on
the controller board has
failed. Contact your InfoPrint
Solutions Company service
representative.
167 ERROR: PROGRAM NEEDS
MORE DRAM No The printer requires more
DRAM to run the
downloaded program. Contact your InfoPrint
Solutions Company service
representative.
168 ERROR: PROGRAM NEEDS
MORE FLASH No The printer requires more
flash memory to run the
downloaded program. Contact your InfoPrint
Solutions Company service
representative.
169 ERROR: PROGRAM NOT
COMPATIBLE No The printer is not compatible
with the downloaded
program. Contact your InfoPrint
Solutions Company service
representative.
170 ERROR: PROGRAM NOT
VALID No The printer does not see a
program in flash memory. Contact your InfoPrint
Solutions Company service
representative.
171 ERROR: SHORT AT
ADDRESS
XXXX
No Hardware failure in DRAM
or controller circuitry. Contact your InfoPrint
Solutions Company service
representative.
172 ERROR: WRITING TO
FLASH No Hardware or software fault
in flash memory. Contact your InfoPrint
Solutions Company service
representative.
173 ERROR: WRONG
CHECKSUM No The printer received the
complete program but the
checksum did not match. Contact your InfoPrint
Solutions Company service
representative.
174 ERROR OCCURRED
FLUSHING QUEUES* No An interim message that
displays while the printer
discards host data it cannot
use because a fault condition
exists. Contact your InfoPrint
Solutions Company service
representative.
175 ACCESS NULL POINTER*
SEE USER’S MANUAL
No Application software tried to
perform an illegal printer
function or damaged logic
circuits were detected on the
controller board. Contact your InfoPrint
Solutions Company service
representative.
180 ETHERNET ADDRESS
ADAPTER NOT INSTALLED Yes The Ethernet PCBA is not
enabled or did not initialize
correctly. Install the Ethernet Address
Adapter.
181 ETHERNET ADAPTER
BEING INITIALIZED N/A Status message indicating
that the Ethernet Interface is
processing the boot
procedure. No action required.
182 ETHERNET DETECTED N/A Status message indicating
that the Ethernet Interface
has established
communication. No action required.
Chapter 7. Routine Service and Diagnostics
231