Inficon Ecotec E3000, Technical Handbook

Page: 61 / 146

Equipment Settings
4-3
ki
n
a
22
e c
h
ap
te
r 4
.fm
te
chn
ica
l ha
nd
boo
k
(1
20
6)
4.2 Sleep Mode
When pressing the
SLEEP
button in the main menu the Ecotec E3000 will go into
sleep mode. The sensor will be shut off and all pumps will be powered down.
However, the Sleep mode menu is still accessible.
The
SLEEP
button will then be replaced by a
START
button.
By pressing the S
TART
button the Ecotec E3000 will be brought back up into
measurement mode.
Notice: The sleep mode does not allow the electrical components to hold their
operating temperature. Therefore, accurate measurements are only
possible again after 20 minutes warm-up time after restarting.
Notice: During Start-up and when in measurement mode, the Ecotec E3000 may
be put to sleep by keeping the lower left button of the main display pressed
and now pressing the lower right button.
4.3 The Service Menu
The service menu is password protected. When entering the service menu a PIN is
required to be entered. The service menu should only be used by trained service
personnel.
The PIN for entering the service menu will be distributed during service training.
Please refer to the service documentation for the submenus and functions of the
service menu.
4.4 Selecting gases and setting gas triggers
The Ecotec E3000 can detect up to four gases simultaneously. In the
GAS TRIGGER
menu the chosen gases are displayed with their currently chosen mass position and
their current trigger value. If a gas is currently disabled for measurement this is also
stated following the mass position.
Fig. 4-2 Setting-up gases and trigger values