Cheetah Pregius Camera with GigE Vision
®
Interface – User Manual
August 27, 2019
Page
96
of
123
Rev 1.0
GevCurrentIPConfigurationDHCP
Indicates whether a DHCP IP configuration scheme
is activated on the network interface.
GevCurrentIPConfigurationPersistentIP
Indicates whether a Persistent IP configuration
scheme is activated on the network interface. A
persistent IP address is hard-coded in non-volatile
memory.
GevCurrentIPAddress
Displays the host computer’s network IP Address.
GevCurrentSubnetMask
Displays the subnet mask of the interface.
GevCurrentDefaultGateway
Displays the default gateway IP address to be used on the
network interface.
GevPersistentIPAddress
Indicates the Persistent IP address for the network interface.
The persistent IP address is re-used by the camera on
power-up when Persistent IP is enabled.
GevPersistentSubnetMask
Indicates the Persistent subnet mask associated with the
Persistent IP address on the network interface.
GevPersistentDefaultGateway
Indicates the Persistent default gateway for the network
interface.
GevLinkSpeed
Indicates the speed of transmission negotiated by network
interface in Mbps.
GevCCP
Enables granting privilege to an application. Options are
open access, exclusive access, or control access.
GevPrimary Application Socket
Indicates the UDP source port of the primary application.
GevPrimary Application IP Address
Indicates the address of the primary application.
GevMCPHostPort
Controls the port to which the device must send messages.
Setting this value to 0 closes the message channel.
GevMCDA
Controls the destination IP address for the message channel.
GevMCTT
Provides the message channel transmission timeout value in
milliseconds.
GevMCRC
Controls the number of retransmissions allowed when a
message channel message times out.
GevMCSP
Indicates the source port for the message channel.
GevSCCFG UnconditionalStreaming
Enables the camera to continue to stream for this
stream channel if its control channel is closed or
regardless of the reception of any ICMP messages (such
as destination unreachable messages).
GevSCPHostPort
Indicates the port to which the device must send data
stream.
GevSCPSFireTestPacket
When this bit is set, the device will fire one test packet.
GevSCPSDoNotFragment
This bit is copied into the "do not fragment" bit of IP header
of each stream packet.
