Cheetah KAC Camera User Manual | Camera Link (CLF) Interface
October 1, 2019
Page
40
of
135
Rev 7.2
Address
:
0x6000
Data (1- 0)
:
00 – Boot from Factory
01 – Boot from User #1
:
10 – Boot from User #2
11 - Reserved
Data (31- 2)
:
N/A
Load From Factory
The ‘Load From Factory’ command instructs the camera to load its workspace from the
factory space. All current workspace settings will be replaced with the contents of the
factory space. This is a command, not a register. The act of writing to this location initiates
the load from the factory.
Address :
0x6060
Load From User #1
The ‘Load From User #1’ command instructs the camera to load its workspace from the user
#1 space. All current workspace settings will be replaced with the contents of the user #1
space. This is a command, not a register. The act of writing to this location initiates the load
from the user #1.
Address :
0x6064
Load From User #2
The ‘Load From User #2’ command instructs the camera to load its workspace from the user
#2 space. All current workspace settings will be replaced with the contents of the user #2
space. This is a command, not a register. The act of writing to this location initiates the load
from the user #2.
Address :
0x6068
Save to User #1
The ‘Save To User #1’ command instructs the camera to save its workspace to the user #1
space. All current workspace settings will be saved to the user #1 space. This is a command,
not a register. The act of writing to this location initiates the save to user #1 space.
Address :
0x6074
Save to User #2
The ‘Save To User #2’ command instructs the camera to save its workspace to the user #2
space. All current workspace settings will be saved to the user #2 space. This is a command,
not a register. The act of writing to this location initiates the save to user #2 space.
Address :
0x6078
