IMG STAGE LINE STA-553D Instruction Manual Download Page 6

6

English

PROT

ON

CLIP

SIG

POWER

PROT

CLIP

SIG

PROT

CLIP

SIG

L-CH

 

R-CH

 

SUB

0

10

STA-553D 

3-CH DIGITAL PA AMPLIFIER

600W 

0

10

0

10

  1 

2  3  4  5 6

50

Hz

250

120

170

230

70

50

Hz

250

120

170

230

70

50

Hz

250

120

170

230

70

SUB

R-CH

L-CH

CROSSOVER

FREQUENCY

L-CH

R-CH

SUB

OUTPUT

SUB

R-CH

L-CH

INPUT

SUB

R-CH

L-CH

MIN.  

LOAD  

4 Ω

3-CH

2-CH

INPUT

MODE

FUSE

230 V~/

50 Hz

 7 

10 

11 

12 

13

• 

Never pull the mains cable for disconnect-
ing the mains plug from the socket, always 
seize the plug .

• 

For cleaning only use a dry, soft cloth; never 
use water or chemicals . 

• 

No guarantee claims for the unit and no li-
ability for any resulting personal damage or 
material damage will be accepted if the unit 
is used for other purposes than originally 
intended, if it is not correctly connected 
or operated, or if it is not repaired in an 
expert way .

If the unit is to be put out of oper-
ation definitively, take it to a local 
recycling plant for a disposal which 
is not harmful to the environment .

4  Installation into a Rack

The amplifier is designed for installation into a 
rack (482 mm /19”); 1 rack space (44 .45 mm) 
is required . To prevent the rack from becom-
ing top-heavy, insert the amplifier into the 
lower section of the rack . The front plate is 
not sufficient for fixing the amplifier safely; 
additionally use lateral rails or a bottom plate 
to secure the amplifier .

To ensure sufficient cooling, air must be 

able to flow freely through all air vents of the 
amplifier . The hot air given off by the amplifier 
must be dissipated from the rack; otherwise, 
heat will accumulate in the rack which may not 
only damage the amplifier but also other units 
in the rack . In case of insufficient heat dissi-
pation, install a ventilation unit into the rack .

3-Channel PA Amplifier  

with Crossover Network

These instructions are intended for users with-
out specific technical knowledge . Please read 
these instructions carefully prior to operating 
the unit and keep them for later reference .

1  Operating Elements and 

Connections

POWER switch

Power indicator ON

Volume controls, one each for the left 
and right channels and for the subwoofer 
channel

LED PROT, one each for each of the three 
channels, will light up when the protection 
circuit is activated and for a few seconds 
after the amplifier has been switched on

Signal indicators SIG (depending on the 
setting of the volume control), one each 
for each of the three channels

Overload LEDs CLIP, one each for each of 
the three channels

Plug-in screw terminals (removable), one 
each for each of the three channels, to 
connect audio sources with line level, e . g . 
mixer
The connections are balanced . When 
connecting audio sources with unbalan-
ced output signal, additionally connect the 
ground connection “G” to “−” .

Controls for adjusting the crossover fre-
quency of the high pass filter, one each 
for the left and right channels

Control for adjusting the crossover fre-
quency of the low pass filter for the sub-
woofer output

10 

Switch INPUT MODE
disengaged:   3 input channels
engaged:  

 2 input channels; subwoo-
fer signal from the signals 
L-CH and R-CH 

11 

Plug-in screw terminals (removable), one 
each for each of the three channels, for 
connecting the speakers; for parallel con-
nection of two speakers, all terminals are 
available twice
Please also refer to chapter 5 .2 .

12 

Support for the mains fuse 

 

Always replace a blown fuse by one of 
the same type .

13 

Mains jack for connection to a socket 
(230 V~/ 50 Hz) via the mains cable sup-
plied

2  Applications

This 3-channel amplifier is designed for PA 
applications at events, e . g . performances 
on stage . It provides three adjustable filters 
that serve as crossover network for the two 
high-frequency/mid-frequency outputs L-CH 
and R-CH and the low-frequency output SUB . 
The signal for the subwoofer can be obtained 
from the stereo input signal or supplied sep-
arately . 

Designed as a class D amplifier and fea-

turing a switch-mode power supply, the 
amplifier is both compact and light . The am-
plifier is protected against short-circuit and 
overheating .

3  Safety Notes 

The unit corresponds to all relevant directives 
of the EU and is therefore marked with   .

WARNING

The unit uses dangerous 
mains voltage . Leave servicing 
to skilled personnel and do 
not insert anything into the 
air vents; inexpert handling 
may result in electric shock .

• 

The unit is suitable for indoor use only . Pro-
tect it against dripping water and splash 
water, high air humidity and heat (admis-
sible ambient temperature range 0 – 40 °C) .

• 

Do not place any vessels filled with liquid 
on the unit, e . g . a drinking glass .

• 

The heat produced inside the unit must 
be dissipated by air circulation; therefore, 
never cover the air vents of the housing .

• 

Do not operate the unit and immediately 
disconnect the mains plug from the socket

1 . if the unit or the mains cable is visibly 

damaged,

2 . if a defect might have occurred after the 

unit was dropped or suffered a similar 
accident,

3 . if malfunctions occur .

In any case the unit must be repaired by 
skilled personnel .

English
English Page

Summary of Contents for STA-553D





















Reviews: