NOTE
It is not recommended to set both the RX and TX Bandwidth limits at the same time. Setting TX
Bandwidth Limits allows for full use of the memory buffers in the unit.
Unit RateControl Enable/Disable –This allows you to enable/disable the bandwidth
limiting feature on this unit.
VII - Application Overview
Before using iMcV-FiberLinX-II in your network, decide the following:
•
Will iMcV-FiberLinX-II units be located at only one or at both ends of the
fiber?
•
How do you want to manage the iMcV-FiberLinX-II units?
•
Will you define VLAN IDs?
How many iMcV-FiberLinX-II units will you use?
•
Two for Host/Remote applications–allows IP-less management providing
greater security
•
One for a single unit application
How do you want to manage iMcV-FiberLinX-II?
You can manage iMcV-FiberLinX-II through any of its three ports (and any
combination thereof) or from the chassis. Using the EXT MGMT/OPTICS (or UPLINK)
port combination separates management traffic from the data and provides the
highest level of security. UMA management does not require an IP address.
Will you define VLAN IDs?
When you want to use VLAN traffic with specific tags on any/all of the DATA ports,
you will need to disable Transparency and define VLAN IDs (refer to VLAN
Configuration section). When you want to use both VLAN tagged, untagged, or
double-tagged traffic, enable Transparency.
33
Summary of Contents for iMcV-FiberLinX-II
Page 1: ...iMcV FiberLinX II Operation Manual...
Page 55: ...Link Fault Pass Through 55...
Page 58: ...Notes 58...
