II - LED Operation
iMcV-FiberLinX-II features diagnostic LEDs. For example, the functions for a 1x9
fiber port version (SC or ST fiber) are shown below:
Port LEDs
FDX/COL:
•
Glows yellow when port is operating in Full-Duplex.
•
Blinks yellow when collisions occur on port.
LNK/ACT:
•
Glows green when link is established on port.
•
Blinks green during data activity on port.
Diagnostic LEDs Optics Port LEDs
FCU (Far CPU Up):
•
Host: Glows green when far
end is detected.
•
Remote: Glows green when
unit is configured as Remote.
•
Standalone Unit: LED remains
OFF.
SNMP:
This LED glows green to indicate
that this is an SNMP manageable
module.
EXT 100:
Glows green when EXT MGMT port
is operating at 100 Mbps.
DATA 100:
Glows yellow when DATA port is
operating at 100 Mbps.
FA: Glows green when FiberAlert is
enabled.
FTL (Far TX Link):
•
Host: Glows green when a link is
established on remote (far-end)
DATA port.
•
Remote: Glows green when unit
is configured as Remote.
•
Standalone: LED remains OFF.
LNK/ACT (Link/Activity):
•
Glows green when link is
established on port.
•
Blinks green during data activity
on port.
FDX/COL (Full Duplex/Collision):
•
Glows yellow when port is
operating in Full-Duplex.
•
Blinks yellow when collisions
occur on port.
NOTE
The all-copper (RJ-45) version has an RJ-45 port with standard Port LEDs, labeled
UPLINK, instead of an Optics Port.
9
Summary of Contents for iMcV-FiberLinX-II
Page 1: ...iMcV FiberLinX II Operation Manual...
Page 55: ...Link Fault Pass Through 55...
Page 58: ...Notes 58...
