VI - Using Telnet
You must assign the iMcV-FiberLinX-II an IP address before using a Telnet session (this
is not necessary when you are using UMA). Refer to the Assigning IP Information
section for more information. All of the configurations that you can perform from the
serial port can also be performed using a Telnet session. You can only use one Telnet
session at a time.
The following are the three levels for Telnet account access:
User: View status, change own password, and reboot.
Operator: All User privileges mentioned above, plus ability to change settings.
Administrator: Operator privileges mentioned above, plus ability to add/delete
accounts and reinitialize the unit to default settings (cleandb).
Serial Configuration/Telnet Session
The following sections describe serial configuration (including VLAN configuration),
Telnet session configuration, and DHCP configuration.
NOTE
Some screens may show TX and FX for the port titles where TX = DATA port and
FX = OPTICS (or UPLINK) port. The examples are from firmware version 512-
00A2.
Serial Port (EXT MGMT)
NOTE
The serial port (EXT MGMT) is always set to Administrator level. Your password
for Telnet sessions is the password that you set and use in iConfig (refer to the
iConfig section for more information).
17
Summary of Contents for iMcV-FiberLinX-II
Page 1: ...iMcV FiberLinX II Operation Manual...
Page 55: ...Link Fault Pass Through 55...
Page 58: ...Notes 58...
