•
Enable FlowControl If Port Allows
Unit FiberAlert – This allows you to enable/disable FiberAlert and LinkLoss
functionality on the unit. The settings include:
•
No FiberAlert Or LinkLoss Enabled
•
FXLinkLoss Only, Enabled
•
TXLinkLoss Only, Enabled
•
FiberAlert Plus FXLinkLoss Enabled
•
FiberAlert Plus TXLinkLoss Enabled
•
TXLinkLoss Plus FXLinkLoss Enabled
•
TXLi FXLi FiberAlert Enabled
•
FiberAlert Only
NOTE
FiberAlert is not offered on the all-copper (RJ-45) version of the iMcV-FiberLinX-II.
Unit LoopBack – This allows you to enable/disable Loopback functionality on the
unit. The settings include the following:
•
No LoopBack, Normal Traffic Mode
•
LoopBack Enabled
•
LoopBack, Src/Dest Address Swap
•
LoopBack, Address Swap, Clear Multicast bit
•
No Learning on OPTICS (or UPLINK) or DATA Ports
Unit Max FrameSz – This allows you to enter the maximum frame size on the unit by
using the number keys.
•
No VLAN–1518
•
VLAN Tag–1522
•
Oversized frames–1536
•
Oversized frames–1916
802.1p Base Pri – This allows you to set the threshold between low and high priority
on the unit. For example, when the Base VLAN Priority is set to 4, priority settings of
31
Summary of Contents for iMcV-FiberLinX-II
Page 1: ...iMcV FiberLinX II Operation Manual...
Page 55: ...Link Fault Pass Through 55...
Page 58: ...Notes 58...