Chapter 4
P12×1-SP Installation, Configuration, and Operation
32
Copyright © 2004-2007, 2008, 2010, Harris Corporation
Figure 4-4
P12×1-SP Ribbon Cable Connections
Setting the DIP
Switches
Each SPT switch configuration section provides appropriate DIP switch settings. A
list of sections (with the corresponding beginning page numbers) is provided on
page 35
To set the DIP switches for your SPT configuration, see the appropriate
configuration section in this chapter for specific operating instructions.
Figure 4-5
on page 33 shows the locations of the SW1 and SW2 DIP switches.
Setting the
RS-232/RS-422
Jumper
Each SPT configuration section provides an RS-232/RS-422 jumper setting. A list of
sections (with the corresponding beginning page number) is provided on
page 35
.
Figure 4-5
on page 33 shows the locations of the RS-232/RS-422 jumper. To set
the RS-232/RS-422 jumper for your SPT configuration, see the appropriate
configuration section in this chapter for specific operating instructions. (See
Jumper Configuration Reference Point
on page 34 for more information about
this jumper’s orientation.)
Reassembling the
Frame
1
Reattach the Panacea Lite frame top to the frame body. Use the original screws
to reattach the top to body.
2
Reinstall the frame back in its rack location.
3
Connect the power input receptacle on the frame to its power source.
