Panacea Lite Routing Switcher Series
Installation, Configuration, and Operation Manual
21
Copyright © 2004-2007, 2008, 2010, Harris Corporation
Installing
Other
Equipment
You can install and configure these modules and options on-site.
Analog Video
Looping Input
Submodule
(P12×1-VL)
1
Disconnect power from the frame.
2
Remove the frame from its rack location and set the frame onto a flat surface.
3
Unscrew the screws on the top of the Panacea Lite frame, then remove the
frame top from the frame body. Set these screws aside, as you will need them
later.
4
On the inside back panel of the router, locate jumpers JT1 through JT12.
5
Remove all of the jumper pins from the jumpers. (You may want to save these
jumper pins; you will need to re-install them if you no longer want the looping
input option on your analog video router.)
6
Reattach the Panacea Lite frame top to the frame body. Use the original screws
to reattach the top to body.
7
Insert the submodule assembly onto the 14 BNC video I/O connectors on the
Panacea Lite frame.
8
Tighten the two thumbscrews located in the upper corners of the submodule
to secure the assembly to the frame.
9
Reinstall the frame back in its rack location.
10
Connect the power input receptacle on the frame to its power source.
11
Attach inputs to the appropriate video I/O connectors (see
Figure 2-17
).
Figure 2-17
P12×1-VL Video I/O Connectors
Audio Signal
Adapter
(P12×1-DTB)
CAUTION: Disconnect power from the frame before removing or
installing adapters. Removing or installing adapters with the power
on could cause serious damage to system components.
1
Disconnect power from the frame.
2
Connect the adapter to the 62-pin D type connectors on the back of the audio
frame.
3
Wire up the audio signal adapter according to the diagram shown in
Figure
2-18
.
