Panacea Lite Routing Switcher Series
Installation, Configuration, and Operation Manual
169
Copyright © 2004-2007, 2008, 2010, Harris Corporation
Figure B-5
Reassembly
1
Remove the fresnel lens from inside the key cap outer lens.
2
Remove desired label artwork from the sheet provided, or use your own
artwork (reproduced on transparent material).
3
Fit the artwork into the outer lens.
4
Snap the fresnel lens into the fitted side of the key cap body (the curved side
of the lens should face the inside of the key cap body). Make sure the face of
this new assembly is flat.
5
Fit the key cap body assembly into the outer lens.
6
Reinstall the lens cap assembly onto the front panel.
7
If you have not already done so, adjust the panel key light intensity. (See the
final step in
Installing a P12×1-CP Control Panel
on page 166 or in
Installing a P12×1-RCP Control Panel
on page 167 for instructions.)
