Appendix B
Control Panel Installation and Operation
172
Copyright © 2004-2007, 2008, 2010, Harris Corporation
P12×1-RCP
DIP Switch
Configura-
tion
DIP switch configuration mode provides limited configuration capability, which
allows you to set the panel’s Destination offset, signal type, and Levels controlled.
These selections are shown in
Figure B-8
on page 172.
Destination Offset
offset the destinations from 0 to 64 using binary code.
Panel ID is the panel’s physical address.
Level 0...7
determine which levels will be affected by this control panel. The
first or lowest consecutive level set on the DIP switch is assigned to the video
level. The next consecutive level set on the DIP switch plus all other levels set in
consecutive order are assigned and follow the audio level. For example, if
poles 2, 4, 6 and 7 are on (i.e., enabled), then the first, or video, level would
be assigned to Level 2. The next, or audio, level would be assigned to Level 3;
plus, Levels 5 and 6 would follow Level 3, the audio level.
Figure B-8
P12×1-RCP DIP Switch Summary
