R E M O T E O P E R A T I O N
Command Syntax
58
LDC-3700C Series
C H A P T E R
3
Note:
If the GPIB times out while waiting for a response, either set the GPIB time-out longer
or use SRQ generated interrupts in your program. See your GPIB manual for time-out
configuration or SRQ programming setup. The
*OPC
,
*OPC?
, and
*WAI
commands
should not be used inside a calibration routine.
Output Off Registers
The Output Off Enable Registers allow you to determine which conditions and
events in the TEC and LASER controllers can cause their outputs to be turned off.
These registers are configured in a manner which is similar to the status reporting
registers. However, their outputs are not reported in the Status Byte Register.
Rather, they go to the hardware which controls the output switching for that
function (LASER or TEC). The events and conditions which may be set to cause
the TEC and LASER outputs to be turned off are shown in Figure 3.6 on page 59
and Figure 3.7 on page 59.
The default (factory) settings for these registers are shown in Table 3.4. These
settings are not effected by the
*PSC
(Power-On Status Clear) command.
Table 3.4
Default Settings for Output Off Registers
LASER Output Off Register
TEC Output Off Register
0- disabled
8- N/A
0- disabled
8- enabled
1- disabled
9- disabled
1- disabled
9- disabled
2- N/A
10- disabled
2- N/A
10- enabled
3- enabled
11- enabled
3- enabled
11- N/A
4- N/A
12- N/A
4- N/A
12- N/A
5- N/A
13- N/A
5- enabled
13- N/A
6- N/A
14- N/A
6- enabled
14- N/A
7- N/A
15- N/A
7- enabled
15- N/A
Summary of Contents for LDC-3700C Series
