Ikegami Editcam 3 DNS-33W, Operation Manual, Page: 63 / 160

DNS-33W 0503 VOL1 (E) DNS-33W
4. OPERATION 4 - 3
4.2.4 Rear Side of the Camera
LINE LINE
ATT
-20dB OFF
MIC MIC +48V +48V
MON
OFF
LINE : When line-inputting the audio
signal to the AUDIO IN CH1/CH2
connectors
MIC : When connecting a microphone to
the AUDIO IN CH1/CH2
connectors
+48V ON : When connecting a microphone
dedicated for phantom powering to
the AUDIO IN CH1/CH2
connectors
MIC ATT switch
AUDIO SELECT
switch
Switch Name Switch Position
4.2.5 Viewfinder
TALLY switch HIGH or LOW
ZEBRA switch ON
Switch Name Switch Position
4.3 Turning ON Power
There are two types of power supplies. One is the supply
from the AC pack and another is from the battery pack. The
way to turn ON the power is common to the two types. Turn
ON the power using the following procedures.
1.
Turn ON the POWER switches of external system such
as AC pack, monitor, and remote controller.
2. Turn ON the POWER switch of the camera.
When the power is turned ON normally, the string
"BOOTING!!" is displayed on the VF screen. Then, the
four LEDs (AUDIO LED) on the right side of the camera
light up in orange.
After the camera is powered on normally, the LEDs once
turn off. Then, the color LCD on the right side of the camera
displays the logo "Ikegami" and the Status screen.
When an FP2 has been loaded in the camera, the logo
"Ikegami" is displayed and the disk is recognized
automatically (recognition requires a few seconds).
■
Turning OFF Power
Turn OFF the power switch.
A few seconds are required to complete the shutdown of the
camera. When the camera is to be restarted, the power must
be turned on 10 seconds or more after powering off.