Ikegami Editcam 3 DNS-33W, Operation Manual, Page: 47 / 160

DNS-33W 0503 VOL1 (E) DNS-33W
2. NAME AND FUNCTION 2 - 17
■
Character Display
AWB Ach
OK
4.3K
●
AWB/ABB displays
●
Status displays
●
Warning displays
1A
NG
1/100
EX RETRO 00:00:00:00
00:00:00
0001 S#-
P.FUNK BLK STR +7% OFF 90
A: 3.2K B:3.2K
+6dB
F16
B
12.0
=|
■
Lens extender operation display
■
Special recording operating mode display
Displays operating mode during the special recording.
During retro loop record: RETRO
During time lapse record : T.LPS
■
Position mark
■
Clip number
■
Clip length
■
Time code
■
AWB color temperature
This color temperature has been stored in AWB memory channel. It appears while
the VF CHARA button is pressed. The channel selected by the AWB select switch
flashes.
■
Remaining disk amount indicator
Displays remaining FP2 disk amount time.
When remaining amount is more than 91 minutes:
>90
When remaining amount is less than 90 minutes: remaining time (Unit: minutes)
■
Shutter speed / Super-V mode
■
Lens F value (See Notice).
+F : IRIS+ CORR ON, +F : IRIS++ CORR ON
■
P.FUNC
Function assigned to the P.FUNC switch is displayed with its status.
■
Battery voltage/remaining charge
The present voltage is indicated when the battery voltage has dropped below the
setting. When the Anton Bauer intelligent battery is used, the present voltage is
indicated when the remaining charge has dropped below the setting.
The voltage setting indicating warnings and the remaining charge setting can be
changed by "POWER MENU" in the menu of the recorder section.
■
AUDIO level indicator
Indicates the input level of audio channels selected by a MONITOR AUDIO SELECT
switch located on the right side of the camera. Input level for CH1 or CH3 is indicated
in the upper bar, and for CH2 or CH4 is indicated in the lower bar.
■
GAIN UP value
■
AWB MEMORY set
A: Ach, B: Bch, 0: OFF
■
Priority right of filter control
Indicates whether the remote controller has the priority right to control the ECC filter.
* : Being controlled by the remote controller
■
ND, ECC Filter position
ND 1 2 3 4
100% 25% 6.2% 1.6%
ECC A B C D
3200K 4300K 6300K 8000K
■
Camera warning displays
Displays warning message of camera.
■
RF warning displays
Displays warnings when a wireless receiver supporting RF warning function is
connected with and the received radio wave level is low.
■
Auto function now being executed
"AWB Ach", "AWB Bch", "ABB", or "A.BLK SHADE"
■
Execution result
"OK" : Appears when the function has been completed.
"NG" : Appears when the function was not completed.
"STOP" : Appears when the execution of the function was
discontinued.
"LEVEL OVER" : Appears when the input signal level is too high.
"LEVEL UNDER" : Appears when the input signal level is too low.
"CHG FILTER"
"COLOR TEMP. HIGH" : Appears when color temperature of the subject is too high.
"COLOR TEMP. LOW"
: Appears when color temperature of the subject is too low.
■
AWB color temperature
The color temperature is indicated here upon completion of AWB.
+
Notice
A correct F value is not displayed for the B3 lens when the IRIS OPERATION SELECT switch of the lens is set
to "M" (Manual). This is due to the specification of the lens and not indicative of a failure.