Ikegami Editcam 3 DNS-33W, Operation Manual

Page: 133 / 160

DNS-33W 0503 VOL1 (E) DNS-33W
7. TROUBLE SHOOTING AND MAINTENANCE 7 - 3
[Camera Front Side]
OFF SHUTT/SUP-V switch
Switch Position
ON
OFF
LE
NS
ON
OFF
AWB
ABB
SHUTT/SUP-V
SHUTT/SUP-V
MENU
VTR
AUDIO OUT
Camera Front Side
SHUTT/SUP-V Switch
[Viewfinder]
HIGH or LOW
ON
ON
TALLY switch
ZEBRA switch
REAR TALLY switch
Switch Position
VF Front Side
TALLY Switch
ZEBRA Switch
REAR TALLY Switch
■
Turning POWER ON
Turn ON the power of the camera and ensure that a normal
color-bar signal is output.
[When AC Pack is Used]
1. Connect the AC pack to the camera and turn ON the
POWER switch of the AC pack.
2.
Turn ON the POWER switch of the camera.
3. Check that a normal color-bar signal is output on the VF
(monitor) screen.
[When Battery Pack is Used]
1. Attach the battery pack to the camera.
2. Turn ON the POWER switch of the camera.
3. Check that a normal color-bar signal is output on the VF
(monitor) screen.
7.2.2 Inspecting the Viewfinder
Inspect following items before shooting to check if the VF
works normally.
1. Adjust the VF position.
For details, refer to "3.4 Mounting the Viewfinder", "
■
Adjusting the Angle and Position".
2. Check that color bars appear in the viewfinder, and then
adjust the BRIGHTNESS knob, CONTRAST knob, and
PEAKING knob in such a way that the color bars appear
most clearly.
VF Front Side
BRIGHTNESS Knob
CONTRAST Knob
PEAKING Knob
3.
Set the OUTPUT SELECT switch to "CAM", switch the
ND FILTER knob to 1 to 2 to 3 to 4. Also, switch the
ECC FILTER SELECT button to A to B to C to D.
During this procedure, check that the character display of
the filter position switches in the VF as the filter position.
The + and – buttons must be pressed and held (for
approximately 0.5 seconds or more) only for the first time
in order to prevent accidental operation.
TCG
PANEL
LIGHT
DNS-
33W
POWER
VF
CHARA
AUDIO
ECC FILTER SELECT Button
ND FILTER
Knob
Camera Right Side
HYPER GAIN
P.FUNC
FIL
HEAD
-
+
4 1.6%
36.2%
22.5%
11.0%
ND
D 8000K
C 6300K
B 4300K
A 3 20K
ECC
ECC
4. Point the camera at a chart or other subject, turn the
focus ring to bring the subject into focus.
Check that the proper image appears on the VF.