Ikegami Editcam 3 DNS-33W, Operation Manual

Page: 54 / 160

DNS-33W DNS-33W 0503 VOL1 (E)
3 - 6 3. INSTALLATION AND CONNECTION
3.4 Mounting the Viewfinder
This section explains how to mount the VF (VF15-32A-S) to
the Camera.
1.
Stand up the eyepiece portion of the VF.
2.
From the left-hand side of the Guide on the front of the
camera, slide the Rail on the rear of the VF.
Slide it to the right until it clicks into position. When the
VF is locked to the camera by the lock pin of the Guide,
it clicks.
3. Connect the VF cable to the VF connector on the camera
handle.
Insert the VF cable while pushing down the connector
lock button of the VF connector until it clicks into
position.
When the cable is locked by the connector lock button, it
clicks.
CAUTION
Be careful not to catch your fingers in the Lock lever
or Guide-Rail when mounting the VF, or you can be
injured.
■
Removing the Viewfinder
This section explains how to remove the VF from the
Camera.
1. Unplug the VF connector while pressing down the
connector lock button.
CAUTION
Forcibly unplugging the connector without pressing
down the connector lock button will place excessive
stress on the cable and may break the cable.
2. Unlock the Left-Right lock lever. While pressing down
the lock release lever, slide and remove the VF.
■
Adjusting the Angle and Position
The eyepiece can be moved so that you can get the most
comfortable eye cup position. The angle of the eyepiece can
also be adjusted in accordance with the camera angle.
[ Adjusting the eyepiece angle ]
The eyepiece can be rotated up to 160 degrees upward and
90 degrees downward.
[ Adjusting position to right and left ]
The VF position can be shifted to the right or left by
loosening the Left-Right lock lever of the camera. Lock the
position after the adjustment.
[ Adjusting position back and forth ]
The VF position can be shifted back and forth by loosening
the Front-Back lock lever of the camera. Lock the position
after the adjustment.
Eyepiece
Front
0 to 250˚
(Up:160˚, Down:90˚)