Ikegami Editcam 3 DNS-33W, Operation Manual, Page: 33 / 160

DNS-33W 0503 VOL1 (E) DNS-33W
2. NAME AND FUNCTION 2 - 3
2.2 Camera Rear Side
This section explains the names and functions of the parts on the rear of the camera.
MON
LINE LINE
ATT
-20dB OFF
MIC MIC +48V +48V
1
2
3
4
6
7
9
8
10
11
5
BACK TALLY Lamp
BACK TALLY Switch
AUDIO SELECT Switches
MIC ATT Switch
AUDIO OUT Connector
AUDIO IN CH1/CH2 Connectors 1
2
3
4
5
6 7
8
9
10
11
MON OUT Connector
DC IN Connector
PHONE Terminal
DC OUT Connector
CAMERA REMOTE Connector
1 BACK TALLY Lamp
Lights up during recording to an FP2 to inform persons
behind the camera operator of recording. However, it does
not light up when the BACK TALLY switch is turned OFF.
2 BACK TALLY Switch
Used to turn ON/OFF the BACK TALLY lamp.
ON
OFF
The BACK TALLY lamp lights up.
The BACK TALLY lamp turns off.
Setting Value Description
3 AUDIO SELECT Switches
Used to select the audio signal.
Switches the audio signal as shown below depending on
the audio input.
LINE
MIC
+48V ON
When line-inputting the audio signal to the
AUDIO IN CH1/CH2 connectors.
When connecting a microphone to the AUDIO IN
CH1/CH2 connectors.
When connecting a microphone dedicated for
phantom powering to the AUDIO IN CH1/CH2
connectors.
Setting Value Description
4 MIC ATT Switch
Used to turn ON/OFF attenuation introduced into the
audio input from the AUDIO IN CH1/CH2 connectors.
Attenuation of approximately -20dB is introduced.
Attenuation is not introduced.
-20dB
OFF
Setting Value Description
5 AUDIO OUT Connector
Used for connecting audio equipment.
6 AUDIO IN CH1/CH2 Connectors
Used to input audio signals from a microphone or line.
7 MON OUT Connector
Connector used to output the video signal (ENC, Y, R, G,
B, R+G+B) set in the camera setting mode (menu) or by
the monitor screen.
During playback, the ENC signal of the playback images
is output.
8 DC IN Connector
Used to 12V DC power to the camera from the
connected AC pack.