Ikegami Editcam 3 DNS-33W, Operation Manual, Page: 57 / 160

DNS-33W 0503 VOL1 (E) DNS-33W
3. INSTALLATION AND CONNECTION 3 - 9
3.6.1 How to Supply Power from an AC Pack
This section explains how to supply power from an AC pack.
WARNING
When connecting an AC pack to the camera, pay
attention to its supply voltage rating. The commercial
power line voltage varies from one country to
another. Therefore, if an AC pack designed for use
in Japan is used in any other country, it may
rupture.
1. Check that the POWER switch on the front of the AC
pack is OFF.
2. Connect the DC cable into the DC OUT connector on the
front of the AC pack.
3.
Connect the DC cable into the DC IN connector on the
rear of the camera.
4.
Connect the AC connector on the front of the AC pack to
an AC power outlet to which commercial power is
supplied.
5. Turn on the POWER switch of the AC pack.
MON
DC Cable
Camera Rear Side
DC IN Connector
AC Pack
DC OUT
Connector
POWER
ON
OFF
POWER Switch AC Outlet
AC Connector
When you turn ON the POWER switch of the camera, the
AC pack supplies power to the camera.
■
Disconnecting the AC Pack
This section explains how to disconnect the AC pack.
1. Turn OFF the POWER switches of the camera and the
AC pack.
2. Push the connector release lever and then disconnect the
DC cable from the DC OUT connector on the front of the
AC pack.
3. Push the connector release lever of the DC cable and then
disconnect the DC cable from the DC IN connector on
the rear of the camera.
4. Disconnect the AC connector on the front of the AC pack
from the AC power outlet to which commercial power is
supplied.
3.6.2 How to Supply Power from a Battery Pack
This section explains how to attach a battery pack to the
camera.
There are several kinds of batteries. For details to connect a
battery, refer to the instruction manual of the battery to be
used. V-mount type of battery is used here as an example.
CAUTION
When connecting the battery to or disconnecting it
from the camera, secure the camera by fastening it
to a tripod or the like. If battery connection /
disconnection is attempted while the camera is not
secured or steady, the camera or battery may fall
and break the equipment or cause injury.
1. Slide the battery pack downward from the upper direction
of the battery bracket to attach the battery pack.
Check that battery pack is firmly attached to the battery
bracket.
Battery Pack
Battery Bracket
When you turn ON the POWER switch of the camera, the
battery pack supplies power to the camera.