Ikegami BS-98, Operation Manual, Page: 30 / 118

16
BS-98 1409 VER1 (U) (E)
2.1 BS-98 Front View
BS-98 Front View With the Front Cover Off
② OPT module ④ SPRC module ⑥ IO module
① RET module
③ HPRC
module
⑤ PLS module
Note:
④
SPRC module is optional.
When the SPRC module is not mounted, "OUT-3" output of the VOUT module on the rear side and "PM OUT" SD-SDI signal cannot
be selected.
At the same time, "ENC OUT" (analog VBS signal) is not output.
① RET module
The detection status of the RETURN signal and the mode are indicated.
Light up when the input signal of RETURN channel#1
has been detected.
IN1
Lights up when It has set the Active loop through.
THRU
Light up when the input signal of RETURN channel#2
has been detected. IN2
Light up when the input signal of RETURN channel#3
has been detected.
IN3
Lights up when It has set the Active loop through. THRU
Light up when the input signal of RETURN channel#4
has been detected. IN4
USB connector for maintenance and service.
Note:
The active loop through output executes the through output only when the equipment power is on.