IHIMER 9VXE, Original Instructions Manual

Page: 78 / 118

MAINTENANCE
9VXE EN 3-9
WB-C310070
MAINTENANCE OF BUCKET
Change the Bucket
•
When the pin is driven with a hammer,
fragments may scatter, resulting in injury. Put
on protective goggles, protective cap and
protective gloves in work.
•
Never insert your finger into the pin holes when
adjusting the pin holes.
Remove the bucket
1. Place the back of the bucket completely on the
ground.
2. Remove the ring pin from the portion (A).
Remove the arm point pin.
3. Remove the ring pin from the portion (B).
Remove the bucket link pin.
4. Raise the arm slowly.
Then remove the arm and the bucket.
Install the bucket
1. Clean the pin holes in the arm and bucket link and
the removed pins. Apply grease to the holes and
pins.
2. Replace the O-rings if they are damaged or worn.
Attach new O-rings to the bosses of the bucket
temporarily.
3. Lower the arm slowly, fit the pin holes in the arm and
bucket, and drive the arm point pin.
4. Attach the ring pin to lock the arm point pin.
5. Raise the boom to move the bucket apart from the
ground and make it free.
6. Extend or contract the bucket cylinder to adjust the
pin hole in the bucket link and bucket. Drive the
bucket link pin into the holes.
7. Attach the ring pin to lock the bucket link pin.
8. Move the O-rings to the proper grooves.
9. Grease the arm point pin and bucket link pin.
WB-C310060
Bucket link
Lock pin
Arm point pin
O-rings
Arm
Bucket link pin
Link pin
Bucket